Rainbow Electronics FARGO MAESTRO 100 (with TCP_IP) - Manual (Page 506)

SIM ToolKit Commands
SIM ToolKit Give Response +STGR
©Restricted
Page: 160 / 202
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001 VOLUME 3 August 23, 2007
Command Responses
AT+STGR=6,1,1 OK
Note: Select Item 1
+STIN: 99
Note: End of session
19.5.6 Notes
• For a GET INKEY with format set to "Yes/No", the data shall contain:
o
the value "y" when the answer is "positive",
o
the value "n" when the answer is "negative".
• For inputs in UCS2 format, the data are entered in ASCII format.
Example: For "8000410042FFFF" entered, the SIM receives 0x00 0x41 0x00
0x42 with UCS2 DCS. (about the different UCS2 syntaxes, please refer to
section "Coding of Alpha fields in the SIM for UCS2" of the Appendixes to AT
Commands Interface Guide).
• Comments upon Terminal Responses:
o
For the SETUP MENU Proactive Command, it is only possible to send a
Terminal Response after the "+STIN: 0" indication, not after a
"AT+STGI=0" request. For the other Proactive Commands, it is possible
to send a Terminal Response after the "+STIN" indication or after the
"+STGI" command.
o
All of the Terminal Responses are not possible with all of the Proactive
Commands. Compatibility between available Terminal Responses and
Proactive Commands is given in section "Support of SIM ToolKit by the
M.E." of the Appendixes to AT Commands Interface Guide. If a Terminal
Response is attempted during a incompatible Proactive Command
session, a "+CME ERROR: 3" will be returned.