Rainbow Electronics FARGO MAESTRO 100 (with TCP_IP) - Manual (Page 473)

SIM Commands
Generic SIM Access +CSIM
©Restricted
Page: 127 / 202
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001 VOLUME 3 August 23, 2007
18.3.3 Parameters and Defined Values
:
Length of the characters that are sent to TE in or
(two times the actual length of the command or
response). For command sent to TE, this value must be in the
range [ 10 – 522 ], else a "+CME ERROR: 3" is returned.
integer type
: Command passed on by the MT to the SIM in the format as
described in 3GPP 11.11 [9] (or 3GPP 51.011 [13]) (hexadecimal
character format; see the +CSCS command).
The supported commands are :
READ BINARY
READ RECORD
FETCH
STATUS
SELECT
SEEK
TERMINAL RESPONSE
ENVELOPE
TERMINAL RESPONSE
hexadecimal type
Second Byte Value not supported:
Due to the absence of locking, a "CME_ERROR: 3" is returned for
the following instructions ( See CRSM commands):
• D6 : UPDATE BINARY
• DC : UPDATE RECORD
• 32 : INCREASE
• 44 : REHABILITATE
• 04 : INVALIDATE
• 88 : RUN GSM ALGORITHM
• 20 : VERIFY CHV
• 24 : CHANGE CHV
• 26 : DISABLE CHV
• 28 : ENABLE CHV
• 2C : UNBLOCK CHV
• FA : SLEEP
• C0 : GET RESPONSE
Second Byte Value warning:
Due to the absence of locking, the right response may not be