Data commands, Using at commands during a data connection, 13 data commands – Rainbow Electronics FARGO MAESTRO 100 (with TCP_IP) User Manual
Page 254

Data Commands
Using AT Commands during a data connection
©Restricted
Page:
64 / 156
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001
VOLUME 2
August 23, 2007
13
Data Commands
13.1
Using AT Commands during a data connection
To use AT commands during a data connection (e.g. while the product is in online
mode), it is necessary to switch to offline mode.
• Switch from online to offline mode
To switch from online mode to offline mode, the "+++" sequence must be sent.
Following this, the product gets back to offline mode with an "OK" response,
and a AT command can be sent. This "+++" sequence must be sent with a
guard time of 1s before and after the sequence.
Note: The "+++" sequence will only work with the +ICF command using one of
the following settings:
o
8 data bits, with no parity
o
7 data bits, with even parity
• Switch from offline to online mode
Please refer to the "O" command description.