Request gprs ip service d – Rainbow Electronics FARGO MAESTRO 100 (with TCP_IP) User Manual
Page 292

GPRS Commands
Request GPRS IP Service D
©Restricted
Page:
102 / 156
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001
VOLUME 2
August 23, 2007
14.6
Request GPRS IP Service D
14.6.1
Description
This command causes the MT to perform whatever actions are necessary to establish
communication between the TE and the external PDN.
The V.25ter "D" (Dial) command causes the MT to enter the V.25ter online data state
and, with the TE, to start the specified layer 2 protocol. The MT returns CONNECT to
confirm acceptance of the command prior to entering the V.25ter online data state.
No further commands may follow on the AT command line.
The detailed behavior after the online data state has been entered is described briefly
in clause 9, for IP, of GSM 07.60.[17] GPRS attachment and PDP context activation
procedures may take place prior to or during the PDP startup if they have not already
been performed using the +CGATT and +CGACT commands.
14.6.2
Syntax
Action command
ATD*
CONNECT
Read command
None
Test command
None
14.6.3
Parameters and Defined Values
GPRS Service Code for IP
digit string (value 99), which identifies a request to use the
GPRS with IP (PDP types IP and PPP)
PDP context identifier
range: 1-4
integer type