Rainbow Electronics FARGO MAESTRO 100 (with TCP_IP) - Manual (Page 636)

I/O Commands
Wavecom Interrupt Pin Configuration +WIPC
©Restricted
Page: 88 / 158
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001 VOLUME 4 August 23, 2007
Command Responses
AT+WIPC? +WIPC: 0,1,0,1
+WIPC: 1,0
OK
22.4.6 Notes
When the INTERRUPT or OFFWHENUNPLUG feature is activated, the two interrupt
pins can be configured independently as interrupt pin or GPIO.
When the NOINTERRUPT feature is activated, the two interrupt pins are configured as
GPIOs even if the value returned by AT+WIPC? is not equal to 0.
The value returned by AT+WIPC? indicates the interrupt pins configuration when the
INTERRUPT or OFFWHENUNPLUG is activated.