Canon imageCLASS MF753Cdw Multifunction Wireless Color Laser Printer - Manual (Page 484)

[On]
[Format Host Rsrcs. MIB to RFC2790]
[Off]
[
On ]
[Use Dedicated Port]
[Menu] [Preferences] [Network]
Specify whether to use a dedicated port.
Use a dedicated port for tasks such as printing from a computer, scanning using the MF Scan Utility, and configuring
or browsing the machine’s settings.
[Off]
[
On ]
[Dedicated Port Auth. Method]
[Menu] [Preferences] [Network]
Set the authentication method when using a dedicated port.
If you specify [Mode 2], communication via the dedicated port will be limited to secure authentication methods only.
This may mean that you cannot connect to the machine from device management software, drivers or other software.
[ Mode 1 ]
[Mode 2]
[Wait Time for Conn. at Startup]
[Menu] [Preferences] [Network]
Set the waiting time until a connection is established when the machine starts up.
If the machine is connected via a device such as a switching hub, you may not be able to connect to the network even
when the setting on the machine is correct. If so, set the waiting time and reconnect.
0 to 300 (sec.)
[Ethernet Driver Settings]
[Menu] [Preferences] [Network]
Set the Ethernet communication method. Manually Configuring the Ethernet Settings(P. 70)
This also allows you to check the MAC address on a wired LAN. Viewing the MAC Address of the Wired LAN(P. 89)
* If the [Communication Mode] is set to [Half Duplex], [1000BASE-T] cannot be selected.
[Auto Detect]
[Off]
[Communication Mode]
[ Half Duplex ]
[Full Duplex]
[Ethernet Type]
[ 10BASE-T ]
Settings Menu Items
474