Fluke Biomedical 601PRO XL - Manual (Page 104)

6 0 1 P R O S E R I E S
X L
6 - 2
1. Connecting the 601PRO and the Host Computer
The serial port parameters of the 601PRO and those of the computer’s
communication program must match. Modify the 601PRO’s baud rate at the
RS232 menu.
• From the MAIN MENU , press SYSTEM SETUP , then RS232 .
• At the RS232 Settings menu, press a SOFT KEY to select a baud rate:
baw130f.eps
• Press enter to return to the MAIN MENU .
☛ Note: The communication program must have RTS/CTS
handshaking selected or large file and higher baud rate
transfers will fail.
• Power DOWN the 601PRO and the host computer.
• Attach one end of the serial cable to the back panel of the 601PRO.
• Attach the other end of the cable to the COM1 or COM2 port on the host
computer.
• Power up the host computer and the 601PRO.
• Load the computer’s communication program and enable it to receive (and
save in a file if desired) the information about to be sent from the 601PRO.
2. Sending Device Information Records from the 601PRO to the
Host Computer
• From the MAIN MENU , press UTILITIES , then DEVICE RECORDS , then
TRANSMIT RECORDS .