Fluke Biomedical 601PRO XL - Manual (Page 103)

6-1
Device Records and Templates
Using its serial port, the 601PRO can transfer device information to and from a
computer, and send stored test results to a computer. The 601PRO has enough
memory to save 1000 device records and/or templates, as well as 225 auto-
sequence test results.
Setup Requirements
❏ Communications software, such as ProComm™, CrossTalk™, Kermit™,
Carbon Copy™ or Fluke Biomedical's OTIS™ must be loaded on the host
computer.
❏ The host computer and the 601PRO both must be set to the same
communications parameters (for example, 2400 Baud, No Parity, 8 Data
Bits, and 1 Stop Bit).
• Set up communication parameters for the 601PRO by pressing
SYSTEM SETUP then RS232 key at the MAIN MENU . Select the
appropriate Baud Rate. The other communications parameters are fixed
at 1 Stop Bit, 8 Data Bits, and No Parity.
• Set up communication parameters for the host computer following
instructions provided with the installed communications software.
❏ A 9-pin male to 9-pin female D-type connector (available from Fluke
Biomedical or an electronics supply outlet) must be attached to the
computer and the 601PRO.
Using the Device Information Record Utility
Use the following checklist to transfer data files from the 601PRO to a
connected personal computer.
1. Connecting the 601PRO and the Host Computer
2. Sending Device Information Records from the 601PRO to
the Host Computer
3. Receiving Device Information Records from the Host
Computer
4. Device Information Record: Definition of Fields
5. Device Information Record Format
6. Deleting Device Records and Templates
Chapter
6