Pilz PSS SB HYD, Basic license - Manual (Page 83)

Modular Block System: Hydraulic Presses 6-21
Error messages
Any fault that is detected will be stored in the corresponding error data
word (
SSNR) of DB 015 (1st data block), until the fault has been fully dealt
with.
• Error messages in DB 015
- Bit 00: T1 N/O and N/C contact open
Remedy: Check input button, cable, input card and all
conditions, then reset (input parameter
RSET)
- Bit 01: T1 N/O and N/C contact closed
Remedy: Check input button, cable, input card and all
conditions, then reset (input parameter
RSET)
- Bit 02: T2 N/O and N/C contact open
Remedy: Check input button, cable, input card and all
conditions, then reset (input parameter
RSET)
- Bit 03: T2 N/O and N/C contact closed
Remedy: Check input button, cable, input card and all
conditions, then reset (input parameter
RSET)
- Bit 04: Two-hand control circuit/console selected, but the console is
disconnected
Remedy: Check switch, cable, input card and all conditions,
then reset (input parameter
RSET)
- Bit 05: Two-hand control circuit/console is deselected, but the console
is connected
Remedy: Check switch, cable, input card and all conditions,
then reset (input parameter
RSET)
- Bit 08: Reset (input parameter RSET) pressed too soon or constantly
pressed
Remedy:
If
RSET input has not been set too early and is contantly high:
Check switch, cable and input card, then reset (input
parameter
RSET)
If RSET input has been set too early: reset again (input
parameter RSET)