Pilz PSS SB HYD, Basic license - Manual (Page 221)

Modular Block System: Hydraulic Presses 6-159
AuSt = 1: Automatic start when PSS starts up
To set automatic start-up on the SB, the input
parameter should be assigned RLO-1 (M 110.01).
• ARst: Automatic restart/reset lock after the enable switch is released
or unlatched from stage 3
ARst = 0:
Reset lock
After the enable switch is released / unlatched, a
reset via the input parameter
RSET is required.
To set the reset lock on the SB, the input
parameter should be assigned RLO-0 (M 110.00).
ARst = 1: Automatic restart after the enable switch is
released / unlatched from stage 3
To set automatic restart for the SB, the input
parameter should be assigned RLO-1 (M 110.01).
• RSET: Error reset
RSET = 0/1-pulse edge: Reset error
Output parameters
• ENBL: Enable flag bit
ENBL = 0: Not enabled
i.e. no approval
ENBL = 1: Enabled
i.e. approval