Pilz PSS SB HYD, Basic license - Manual (Page 217)

Modular Block System: Hydraulic Presses 6-155
Error messages
Any fault that is detected will be stored in the corresponding error data
word (
SSNR) of DB015 (1st data block), until the fault has been fully dealt
with.
• Error messages in DB015
- Bit 01: Valve acknowledgement input parameter S1 remains high
after the valve is switched on.
Remedy: Check switch, cable, input card and all conditions,
and then reset (input parameter
RSET)
- Bit 02: Valve acknowledgement input parameter S1 remains low after
the valve is switched off.
Remedy: Check switch, cable, input card and all conditions
and then reset (input parameter
RSET)
INFORMATION
If no reaction time has been set for switching off the valve
(
TOff = 0), Bit 02 will remain set until the valve returns to its
start position. This is not a fault, but is important to bear in
mind.
- Bit 03: Valve acknowledgement input parameter S1 goes to its start
position during operation (input parameter S1 goes high while
output parameter Y1 = 1)
Remedy: Check switch, cable, input card and all conditions
and then reset (input parameter
RSET)
- Bit 04: Valve Y1 not in its start position (off) when switched on (input
parameter
S1
=
0)
Remedy: Check switch, cable, input card and all conditions
and then reset (input parameter
RSET)
- Bit 05: Valve acknowledgement input parameter S2 remains high
after the valve is switched on
Remedy: Check switch, cable, input card and all conditions
and then reset (input parameter
RSET)