Pilz PSS SB HYD, Basic license - Manual (Page 298)

9-10
Appendix
Modular Block System: Hydraulic Presses
Changes from Version 1.0 to Version 1.1:
• Input parameter
SSDB removed
• Input parameter KUs renamed KU_S
• Input parameter KURe renamed KU_R
• Input parameters RVen, SPSV, RPSV, WBan, WBim introduced.
Changes from Version 1.1 to Version 1.2:
• Input parameters
SPSV, RPSV, WBan, WBim removed
SB071: Initialisation of administration data blocks (DB015/DB016/DB017)
Version Date CRC
1.0 19.07.02 DF40
SB072: Temporary suspension of safety functions (ESPE/AOPD muting)
Version Date CRC
1.0 19.02.98 F0A0
1.1 25.02.00 CAF3
Changes from Version 1.0 to Version 1.1:
• Monitoring times
- TMut Timer Muting
- TS12 Time Sequential
- TOPD Timer (active) Optoelectronic Protective Device
can no longer be deactivated. The value “0” which previously led to
deactivation is now interpreted as a time value of 0 ms.
• When using input parameter TOff (condition: TOff is not statically set to
0), it was previously possible for the control system to switch to a STOP
condition with error message F-0C, if SB 072 detected an error at the
muting station during parallel muting. This no longer happens.
Now, the enable
ENBL from SB 072 is reset and the corresponding error
bit is set.