Pilz PSS SB HYD, Basic license - Manual (Page 303)

9-15 Modular Block System: Hydraulic Presses
Changes from Version III to Version IV
The status of standards has been updated throughout the manual.
Old New Change
page page
3-8 3-8 Feedback loop monitoring SB067
3-9 3-9 Information on input circuitry SB068
3-10 3-10 Information on input circuitry SB069
3-11 3-12 Information on input circuitry SB072
4-45 4-45 Information on safety query from E-STOP buttons S068
4-46 4-46 SSeq=0
4-46 4-46 “Danger” note, input parameter RLO=0 (M110.00)
4-47 4-48 “Information” note amended to “Warning”
4-48 4-48 Wiring for category 4
4-49 4-49 Function test
4-50 4-50 CyRs=0/1-pulse edge
4-51 4-51 Reset hardware error
4-52 4-52 Other messages Bit 10, Bit 13
4-66 4-66 Function of SB 070
4-67 4-67 Table for setting global parameters
4-68 4-68 Use of type 2 ESPE/AOPD for parameter RBWS
4-73 4-73 Wiring the input parameter
6-34 6-34 Set operating mode ARSt=0
6-36 6-36 “Danger” note, “potentially dangerous movement”
6-37 6-37 Setting the block parameters M110.00 (RLO-0) -ARSt
6-38 6-38 “Danger” note, “potentially dangerous movement”
6-39 6-39 Setting the block parameters M110.00 (RLO-0) -ARSt
6-40 6-40 “Danger” note, “potentially dangerous movement”
6-41 6-41 Setting the block parameters M110.00 (RLO-0) -ARSt
Changes to the operating manual