Function test on the gate (input parameter noft), Standard function blocks, Sb075 – Pilz PSS SB HYD, Basic license User Manual
Page 176

6-114
Modular Block System: Hydraulic Presses
Standard Function Blocks
Function test on the gate (input parameter
NoFT)
If a function test is required on the gate (
NoFT = 0), a function test must be
performed on the gate after each
• Unlocking of the gate
• PSS warm start
• PSS cold start or
• SafetyBUS p: I/O-Group start (input parameter
GRP must be assigned
the status flags of the relevant I/O-Groups)
Whether or not a reset is required after performing the function test is
defined via the input parameters
ARSt or AuSt (after each PSS cold/warm
start or I/O-Group start).
SB075
This manual is related to the following products:
- PSS SB HYD, General license PSS SB HYD, Copy license PSS SB HYD, Update license PSS SB TRA, Basic License PSS SB TRA, General license PSS SB TRA, Copy license PSS SB TRA, Update license PSS SB NOT, Basic license PSS SB NOT, general license PSS SB NOT, Copy license PSS SB NOT, Update license PSS SB FT, Basic license PSS SB FT, General license PSS SB FT, Copy license