Pilz PSS SB HYD, Basic license - Manual (Page 292)

9-4
Appendix
Modular Block System: Hydraulic Presses
• Addition of output parameter RSET.
This output parameter signals a change in operating mode through a 1-
signal for the length of one PSS cycle.
SB052: Operating mode selector switch, 2 from 6
Version Date CRC
1.0 22.05.96 4B50
1.1 15.08.97 BB6F
STOP
1.2 15.12.97 BF70
Changes from Version 1.0 to Version 1.1
• Name changed from “BA_1aus6” to “BA_1AUS6”
• Addition of input parameter TIME.
This input parameter enables you to adjust the contact switchover time
on the operating mode selector switch.
Permitted value range for the contact switchover time: 1 ... 255 ms
• Addition of output parameter RSET.
This output parameter signals a change in operating mode through a 1-
signal for the length of one PSS cycle.
Changes from Version 1.1 to Version 1.2
• Input parameter
TIME
Maximum permitted contact switchover time increased from 255 ms to
1023 ms