Pilz PSS SB HYD, Basic license - Manual (Page 225)

Modular Block System: Hydraulic Presses 6-163
Error messages
Any fault that is detected will be stored in the corresponding error data
word (
SSNR) of DB015 (1st data block), until the fault has been fully dealt
with.
• Error messages in DB015
- Bit 00: Enable switch is fully operated (E-STOP)
Remedy: Release enable switch, check switch, cable, input
card and all conditions, and then reset (input parameter
RSET).
- Bit 01: N/O contact on the enable switch is defective (input parameter
NO)
Remedy: Check switch, cable, input card and all conditions,
and then reset (input parameter
RSET).
- Bit 08: RSET input constantly high or set too early
Remedy: Check switch, cable, input card and all conditions,
and then reset (input parameter
RSET).
- Bit 09: RSET input not yet operated, no reset present
Remedy: Press reset button (input parameter
RSET)
• Error messages on the CPU-display
- None
Global parameters used in administration data block DB015
• None
Blocks required
• DB015: Administration data block
DB015 must consist of its total length of 1024 data words
DB015 must have READ/WRITE access.