Pilz PSS SB HYD, Basic license - Manual (Page 227)

Modular Block System: Hydraulic Presses 6-165
• 1OUT: Input for selecting whether both muting lamps are to be tested
simultaneously or alternately.
1OUT =1: Lamps are tested simultaneously. If positive-
switching outputs are used, output parameters
LMP1 and LMP2 can both be assigned the address
of a single output. Two optocouplers will need to be
connected to the PSS output.
If negative-switching outputs are used, two PSS
outputs will be needed.
1OUT= 0: Lamps are tested alternately. The output parameters
LMP1 and LMP2 must be assigned two different
addresses.
Output parameters
• ENBL: Enable flag bit
ENBL = 1: At least one filament is in order.
ENBL = 0: Fault detected: A defect has been found on both
filaments or on the optocouplers.
• WARN: Warning
WARN = 1: One of the two filaments is defective.
WARN = 0: Both filaments are in order.
• LMP1: Output for driving muting lamp 1 (Lamp 1)
LMP1 = 1: Muting lamp 1 on
LMP1 = 0: Muting lamp 1 off
• LMP2: Output for driving muting lamp 2 (Lamp 2)
LMP2 = 1: Muting lamp 2 on
LMP2 = 0: Muting lamp 2 off