Pilz PSS SB HYD, Basic license - Manual (Page 117)

Modular Block System: Hydraulic Presses 6-55
Error messages
Any fault that is detected will be stored in the corresponding error data
word (
SSNR) of DB015 (1st data block), until the fault has been fully dealt
with.
• Error messages in DB015
- Bit 00: Faults which occur as the pulse edge changes at the input
parameter EIN
RFK 1 remains open
Remedy: Check contacts, cable, input card and all conditions
and then reset (input parameter
RSET)
- Bit 01: Faults which occur as the pulse edge changes at the input
parameter
EIN
RFK 1 remains closed
Remedy: Check contacts, cable, input card and all conditions
and then reset (input parameter
RSET)
- Bit 02: Faults which occur as the pulse edge changes at the input
parameter
EIN
RFK 2 remains open
Remedy: Check contacts, cable, input card and all conditions
and then reset (input parameter
RSET)
- Bit 03: Faults which occur as the pulse edge changes at the input
parameter
EIN
RFK 2 remains closed
Remedy: Check contacts, cable, input card and all conditions
and then reset (input parameter
RSET)
- Bit 04: Faults which occur as the pulse edge changes at the input
parameter
EIN
RFK 1 interrupted
Remedy: Check contacts, cable, input card and all conditions
and then reset (input parameter
RSET)
- Bit 05: Faults which occur as the pulse edge changes at the input
parameter
EIN
RFK 1 closed
Remedy: Check contacts, cable, input card and all conditions
and then reset (input parameter
RSET)