ADTRAN 5000 Series - Manual (Page 892)

Command Reference Guide PPP Interface Configuration Command Set
61200990L1-35E Copyright © 2005 ADTRAN 892
bridge-group bpduguard [enable | disable]
Use the bridge-group bpduguard command to block BPDUs from being received on this interface. To
return to the default value, use the no form of this command.
Syntax Description
Assigns a bridge group number (range: 1 to 255).
enable Enables the BPDU block.
disable Disables the BPDU block.
Default Values
By default, this command is set to disable.
Applicable Platforms
This command applies to the NetVanta 5000 Series units.
Command History
Release 5.1 Command was introduced.
Usage Examples
The following example enables the BPDU guard on the interface:
(config)#interface ppp 1
(config-ppp 1)#bridge-group 1 bpduguard enable