Match – ADTRAN 5000 Series User Manual
Page 1165
Command Reference Guide
Quality of Service (QoS) Map Commands
61200990L1-35E
Copyright © 2005 ADTRAN
1165
match
Use the match command to specify which traffic should be processed by this QoS map. Possible variations
of this command include:
match dscp <0-63>
match ip rtp
match ip rtp
match ip rtp
match list
match precedence <0-7>
match protocol bridge
match protocol bridge netbeui
Syntax Description
dscp <0-63>
Matches IP packets with the specified DSCP value.
ip rtp
Matches RTP packets with even UDP destination port numbers in the
specified range (between start and end). If all (which is optional) is specified,
even and odd ports are matched in the specified range.
list
Specifies the name of the access-list (ACL) you wish to use to match packets
for this QoS map. Refer to
for
more information on creating access-lists.
precedence <0-7>
Matches IP packets with the specified IP precedence value.
protocol bridge
Matches frames being bridged by the router.
protocol bridge netbeui
Matches only NetBEUI frames being bridged by the router.
Default Values
No default value is necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 6.1
Command was introduced.
Usage Examples
The following example assigns a traffic match pattern to the existing QoS map VOICEMAP:
(config)#qos map VOICEMAP 10
(config-qos-map)#match ip rtp 16384 20000