ADTRAN 5000 Series - Manual (Page 641)

Command Reference Guide Demand Interface Configuration Command Set
61200990L1-35E Copyright © 2005 ADTRAN 641
connect-sequence
Use the connect-sequence command to provide instructions to the interface on how to use the resource
pool and telephone numbers to connect to demand destinations. Use the no form of this command to
restore the default values.
Variations of this command include the following:
connect-sequence dial-string forced-analog
connect-sequence dial-string forced-analog busyout-threshold
connect-sequence dial-string forced-isdn-56k
connect-sequence dial-string forced-isdn-56k
busyout-threshold
connect-sequence dial-string forced-isdn-64k
connect-sequence dial-string forced-isdn-64k
busyout-threshold
connect-sequence dial-string isdn-56k
connect-sequence dial-string isdn-56k busyout-threshold
connect-sequence dial-string isdn-64k
connect-sequence dial-string isdn-64k busyout-threshold
Syntax Description
Specifies the number for this connection specification entry. Range: 1 to 65,535.
Specifies the telephone number to dial when using this connection. The dial
string is limited to 20 digits.
forced-analog Specifies that only analog resources may be used.
forced-isdn-56k Specifies that only ISDN resources may be used. Call is placed using ISDN 56k.
forced-isdn-64k Specifies that only ISDN resources may be used. Call is placed using ISDN 64k.
isdn-56k Specifies any dial resource may be used if ISDN 56k call-type is used.
isdn-64k Specifies any dial resource may be used if ISDN 64k call-type is used.
busy-threshold Optional. Specifies the maximum number of connect sequence cycles during a
activation attempt that must fail before it is skipped until the next activation
attempt.
Default Values
By default any dial resource may be used.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 Series units.
Command History
Release 11.1 Command was introduced.