Password Page 1036
Page 1036
Command Reference Guide
CA Profile Configuration Command Set
61200990L1-35E
Copyright © 2005 ADTRAN
1036
password
Use the password command to specify the challenge password for simple certificate exchange protocol
(SCEP). Use the no form of this command to allow CA requests to be sent automatically (using SCEP)
without requiring a password.
Syntax Description
Specifies the SCEP password (up to 80 characters).
Default Values
By default, no password is required.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 5.1
Command was introduced.
Functional Notes
There are two places for configuring a SCEP password:
•
At the (ca-profile)# prompt.
•
If it is not configured at the (ca-profile)# prompt, you are prompted to enter one when going through the
certificate enrollment process.
The password is sent to the CA from which you are requesting a certificate. The CA may then ask for the
password later before a certificate can be revoked. Refer to
Usage Examples
The following example sets the SCEP challenge password to adtran:
(ca-profile)#password adtran