ADTRAN 5000 Series - Manual (Page 469)

Command Reference Guide Global Configuration Mode Command Set
61200990L1-35E Copyright © 2005 ADTRAN 469
username password
Use this command to configure the username and password to use for all protocols requiring a
username-based authentication system including FTP server authentication, line (login local-user list), and
HTTP access.
Syntax Description
Specifies a username using an alphanumerical string up to 30 characters in length
(the username is case-sensitive).
Specifies a password using an alphanumerical string up to 30 characters in length
(the password is case-sensitive).
Default Values
By default, there is no established username and password.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 1.1 Command was introduced.
Functional Notes
All users defined using the username/password command are valid for access to the unit using the login
local-userlist command.
Usage Examples
The following example creates a username of ADTRAN with password ADTRAN:
(config)#username ADTRAN password ADTRAN
CODEC List Command Set on page 1586 Voice Trunk Group Command Set on page 1684 Voice User Com-
mand Set on page 1734 Voice Trunk Analog LS/GS Command Set on page 1660 Voice Trunk Analog DPT
Command Set on page 1640 Voice Trunk ISDN Command Set on page 1689 Voice Trunk T1 Wink Command
Set on page 1717 VLAN Configuration Command Set on page 655