ADTRAN 5000 Series - Manual (Page 203)

Command Reference Guide Enable Mode Command Set
61200990L1-35E Copyright © 2005 ADTRAN 203
show ip dhcp-client lease
Use the show ip dhcp-client lease command to display all Dynamic Host Client Protocol (DHCP) lease
information for interfaces that have dynamically assigned IP addresses.
Syntax Description
Optional. Displays the information for the specified interface. Type show ip
dhcp-client lease ? for a complete list of applicable interfaces.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 2.1 Command was introduced.
Usage Examples
The following is a sample output from the show dhcp-client lease command:
>enable
#show dhcp-client lease
Interface: ethernet 0/1
Temp IP address: 10.100.23.64 Mask: 0.0.0.0
DHCP Lease server: 10.100.23.207 State: Bound (3)
Lease: 120 seconds
Temp default gateway address: 0.0.0.0
Client-ID: N/A