ADTRAN 5000 Series - Manual (Page 874)

Command Reference Guide Loopback Interface Configuration Command Set
61200990L1-35E Copyright © 2005 ADTRAN 874
ip policy route-map
Use the ip policy route-map command to assign a policy route-map to this interface. Use the no form of
this command to remove the route-map policy.
Syntax Description
Specifies the name of the policy route map to assign to this interface.
Default Values
By default, no policy route map is assigned to this interface.
Applicable Platforms
This command applies to the NetVanta 2000 and 5000 and Total Access 900 Series units.
Command History
Release 11.1 Command was introduced.
Usage Examples
The following example assigns the policy route map policy1 to the interface:
(config)#interface loopback 1
(config-loop 1)#ip policy route-map policy1