ADTRAN 5000 Series - Manual (Page 36)

Command Reference Guide Enable Mode Command Set
61200990L1-35E Copyright © 2005 ADTRAN 36
E NABLE M ODE C OMMAND S ET
To activate the Enable mode, enter the enable command at the Basic mode prompt. (If an enable password
has been configured, a password prompt will display.) For example:
>enable
Password: XXXXXXX
#
The following command is common to multiple command sets and is covered in a centralized section of
this guide. For more information, refer to the section listed below:
exit on page 34
All other commands for this command set are described in this section in alphabetical order.
clear commands begin on page 38
clock auto-correct-dst on page 76
clock no-auto-correct-dst on page 77
clock set on page 78
clock timezone on page 79
configure [memory | network | overwrite-network | terminal] on page 82
copy on page 83
copy console on page 84
copy flash on page 85
copy interface on page 86
copy tftp on page 87
copy xmodem on page 88
debug commands begin on page 89
dir on page 141
dir [ | flash | flash ] on page 142
disable on page 143
enable on page 144
erase [ | startup-config] on page 145
events on page 146
exception report generate on page 147
logout on page 148
ping on page 149
reload [cancel | in ] on page 151
show commands begin on page 152