Ip ospf – ADTRAN 5000 Series User Manual
Page 821
Command Reference Guide
HDLC Command Set
61200990L1-35E
Copyright © 2005 ADTRAN
821
ip ospf
Use the ip ospf command to customize OSPF settings (if needed).
Syntax Description
authentication-key
Specifies a simple-text authentication password to be used
by other routers using
password authentication.
cost
Specifies the OSPF cost of sending a packet on the interface.
This value overrides any computed cost value.
Range: 1 to 65535.
dead-interval
Sets the maximum interval allowed between hello packets. If
the maximum is exceeded, neighboring devices will
determine that the device is down. Range: 0 to 32767.
hello-interval
Specifies the interval between hello packets sent on the
interface. Range: 0 to 32767.
message-digest-key
Configures OSPF Message Digest 5 (MD5) authentication
(16-byte max) keys.
priority
Set the OSPF priority. The value set in this field helps
determine the designated router for this network.
Range: 0 to 255.
retransmit-interval
Specifies the time between link-state advertisements (LSAs).
Range: 0 to 32767.
transmit-delay
Sets the estimated time required to send an LSA on the
interface. Range: 0 to 32767.
Default Values
retransmit-interval
5 seconds
transmit-delay
1 second
hello-interval
10 seconds: Ethernet, point-to-point, Frame Relay, and PPP
dead-interval
40 seconds
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 3000, 4000, and 5000 and Total Access 900 Series
units.
Command History
Release 9.1
Command was introduced.