Ip ospf – ADTRAN 5000 Series User Manual
Page 558
Command Reference Guide
Ethernet Interface Configuration Command Set
61200990L1-35E
Copyright © 2005 ADTRAN
558
ip ospf
Use the ip ospf command to customize OSPF settings (if needed).
Default Values
dead-interval
40 seconds
hello-interval
10 seconds: Ethernet, point-to-point, Frame Relay, and PPP
retransmit-interval
transmit-delay
1 second
Applicable Platforms
This command applies to the NetVanta 300, 2000, 3000, 4000, and 5000 and Total Access 900 Series
units.
Command History
Release 3.1
Command was introduced.
Release 5.1
Command was expanded to include Ethernet sub-interfaces.
Syntax Description
authentication-key
Assigns a simple-text authentication password to be used by other routers
using the OSPF simple password authentication.
cost
Specifies the OSPF cost of sending a packet on the interface. This value
overrides any computed cost value. Range: 1 to 65,535.
dead-interval
Sets the maximum interval allowed between hello packets. If the maximum
is exceeded, the neighboring device is assumed to be down.
Range: 0 to 32,767.
hello-interval
Specifies the interval between hello packets sent on the interface.
Range: 0 to 32,767.
message-digest-key
Configures OSPF Message Digest 5 (MD5) authentication (16-byte max)
keys.
priority
Sets the OSPF priority. The value set in this field helps determine the
designated router for this network. Range: 0 to 255.
retransmit-interval
Specifies the time between link-state advertisements (LSAs).
Range: 0 to 32,767.
transmit-delay
Sets the estimated time required to send an LSA on the interface.
Range: 0 to 32,767.