ADTRAN 5000 Series - Manual (Page 1145)

Command Reference Guide DHCP Pool Command Set
61200990L1-35E Copyright © 2005 ADTRAN 1145
DHCP P OOL C OMMAND S ET
To activate the DHCP Pool mode, enter the ip dhcp-server pool command at the Global Configuration
mode prompt. For example:
>enable
#configure terminal
(config)#ip dhcp-server pool MyPool
(config-dhcp)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#>
on page 28
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
client-identifier on page 1146
client-name on page 1148
default-router on page 1149
dns-server on page 1150
domain-name on page 1151
hardware-address on page 1152
host on page 1154
lease on page 1155
netbios-name-server on page 1156
netbios-node-type on page 1157
network on page 1158
ntp-server on page 1159
option [ascii | hex | ip] on page 1160
tftp-server on page 1161
timezone-offset on page 1162