ADTRAN 5000 Series - Manual (Page 101)

Command Reference Guide Enable Mode Command Set
61200990L1-35E Copyright © 2005 ADTRAN 101
debug frame-relay [events | llc2 | lmi]
Use the debug frame-relay command to activate debug messages associated with the Frame Relay
operation. Debug messages are displayed (real time) to the terminal (or Telnet) screen. Use the no form of
this command to disable the debug messages.
Syntax Description
events Activates debug messages for generic Frame Relay events (such as Frame Relay
interface state).
llc2 Activates debug messages for the logical link control layer.
lmi Activates debug messages for the local management interface (such as DLCI
status signaling state, etc.).
Default Values
By default, all debug messages in the AOS are disabled.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 and Total Access 900 Series units.
Command History
Release 1.1 Command was introduced.
Functional Notes
The debug frame-relay command activates debug messages to aid in the troubleshooting of Frame Relay
links.
Usage Examples
The following example activates all possible debug messages associated with Frame Relay operation:
>enable
#debug frame-relay events
#debug frame-relay llc2
#debug frame-relay lmi