ADTRAN 5000 Series - Manual (Page 714)

Command Reference Guide Frame Relay Sub-Interface Config Command Set
61200990L1-35E Copyright © 2005 ADTRAN 714
F RAME R ELAY S UB -I NTERFACE C ONFIG C OMMAND S ET
To activate the Frame Relay Sub-Interface Configuration mode, enter the interface frame-relay command
(and specify a sub-interface) at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface frame-relay 1.16
(config-fr 1.16)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
description on page 31
cross-connect <#>
on page 28
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
access-policy on page 715
bandwidth on page 718
bridge-group on page 719
crypto map on page 720
dial-backup commands begin on page 722
dynamic-dns [dyndns | dyndns-custom | dyndns-static] on
page 738
frame-relay commands begin on page 740
ip commands begin on page 744
lldp receive on page 772
lldp send [management-address l port-description l system-capabilities l system-description l
system-name l and-receive] on page 773
mtu on page 775
spanning-tree commands begin on page 776