ADTRAN 5000 Series - Manual (Page 592)

Command Reference Guide G.703 Interface Configuration Command set
61200990L1-35E Copyright © 2005 ADTRAN 592
G.703 I NTERFACE C ONFIGURATION C OMMAND SET
To activate the G.703 Interface Configuration mode, enter the interface e1 command (and specify the
G.703 port) at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface e1 1/2
(config-e1 1/2)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <“text”> on page 27
cross-connect <#>
on page 28
description on page 31
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
coding [ami | hdb3] on page 593
framing [crc4] on page 594
loopback network [line | payload] on page 595
snmp trap link-status on page 596
test-pattern [ones | zeros] on page 597
ts16 on page 598