ADTRAN 5000 Series - Manual (Page 692)

Command Reference Guide Frame Relay Interface Config Command Set
61200990L1-35E Copyright © 2005 ADTRAN 692
F RAME R ELAY I NTERFACE C ONFIG C OMMAND S ET
To activate the Frame Relay Interface Configuration mode, enter the interface frame-relay command at
the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface frame-relay 1
(config-fr 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <“text”> on page 27
cross-connect <#>
on page 28
description on page 31
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
bandwidth on page 693
encapsulation frame-relay ietf on page 694
fair-queue on page 695
frame-relay commands begin on page 696
hold-queue out on page 708
max-reserved-bandwidth on page 709
qos-policy out on page 710
snmp trap on page 712
snmp trap link-status on page 713