ADTRAN 5000 Series User Manual

Page 209

Command Reference Guide

Enable Mode Command Set

61200990L1-35E

209

show ip mroute [ | ] [summary | all]

Use the show ip mroute command to display IP multicasting routing table information.

Syntax Description

Optional. Displays IP address of a multicast group.

Optional. Displays the parameters for a specific interface (in the format type
slot/port). For example: eth 0/1.

summary

Optional. Displays a single-line summary for each entry in the IP multicast routing
table.

all

Optional: Displays all multicast routes, including those not used to forward
multicast traffic.

Default Values

No default value necessary for this command.

Applicable Platforms

This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.

Command History

Release 7.1

Command was introduced.

Release 9.1

Command was expanded to include HDLC and tunnel interfaces.

Release 11.1

The All option was added.

Usage Examples

The following is sample output from the show ip mroute command:

>enable

#show ip mroute

IP Multicast Routing Table
Flags: S - Sparse, C - Connected, P - Pruned, J - Join SPT, T - SPT-bit Set,
F - Register, R - RP-bit Set
Timers: Uptime/Expires

(*, 225.1.0.1), 01:16:21/00:02:45, RP 192.168.0.254, Flags: SC
Incoming interface: tunnel 2, RPF nbr 172.16.2.10
Outgoing interface list:
eth 0/1, Forward, 01:16:21/00:02:45