ADTRAN 5000 Series User Manual
Page 280
Command Reference Guide
Enable Mode Command Set
61200990L1-35E
Copyright © 2005 ADTRAN
280
write [dynvoice-config | erase | memory | network | terminal]
Use the write command to save the running configuration to the unit’s nonvolatile random access memory
(NVRAM) or a Trivial File Transfer Protocol (TFTP) server. Also use the write command to clear
NVRAM or to display the running configuration on the terminal screen. Entering the write command with
no other arguments copies your configuration changes to the unit’s NVRAM. Once the save is complete,
the changes are retained even if the unit is shut down or suffers a power outage.
Syntax Description
dynvoice-config
Optional. Writes dynvoice configuration information to the unit’s NVRAM.
erase
Optional. Erases the configuration files saved to the unit’s NVRAM.
memory
Optional. Saves the current configuration to NVRAM. Refer to
for more information.
network
Optional. Saves the current configuration to the network TFTP server. Refer to
for more information.
terminal
Optional. Displays the current configuration on the terminal screen.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 3.1
Command was introduced.
Usage Examples
The following example saves the current configuration to the unit’s NVRAM:
>enable
#write memory