ADTRAN 5000 Series - Manual (Page 560)

Command Reference Guide Ethernet Interface Configuration Command Set
61200990L1-35E Copyright © 2005 ADTRAN 560
ip ospf network [broadcast | point-to-point]
Use the ip ospf network command to specify the type of network on this interface.
Syntax Description
broadcast Sets the network type for broadcast.
point-to-point Sets the network type for point-to-point.
Default Values
By default, Ethernet defaults to broadcast. PPP and Frame Relay default to point-to-point.
Applicable Platforms
This command applies to the NetVanta 300, 2000, 3000, 4000, and 5000 and Total Access 900 Series
units.
Command History
Release 3.1 Command was introduced.
Release 5.1 Command was expanded to include Ethernet sub-interfaces
Functional Notes
A point-to-point network will not elect designated routers.
Usage Examples
The following example designates a broadcast network type:
(config)#interface eth 0/1
(config-eth 0/1)#ip ospf network broadcast