ADTRAN 5000 Series - Manual (Page 1075)

Command Reference Guide IKE Policy Command Set
61200990L1-35E Copyright © 2005 ADTRAN 1075
client authentication host
Use the client authentication host command to enable the unit to act as an Xauth host when this IKE
policy is negotiated with a peer.
Variations of this command include the following:
client authentication host username
client authentication host username password
client authentication host username password passphrase
Syntax Description
username Specifies the value sent via Xauth as the username.
password Specifies the value sent via Xauth as the password.
passphrase Optional. Specifies the value sent via Xauth as the passphrase. This is only used with
authentication type OTP (one time password).
Default Values
By default, if this command is not present in the IKE policy the unit does not act as an Xauth host.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 5.1 Command was introduced.
Functional Notes
The specified credentials are programmed into the unit and there is no prompt for entering values
real-time. Therefore, schemes requiring real-time input or additional responses (e.g., SecureID) are not
supported. The client authentication host command and the client authentication server commands
are mutually exclusive. Refer to
client authentication server list on page 1077 for more
information.
Usage Examples
The following example specifies the login credentials to be sent:
(config-ike)#client authentication host username jsmith password password1 passphrase phrase