ADTRAN 5000 Series - Manual (Page 1041)

Command Reference Guide Certificate Configuration Command Set
61200990L1-35E Copyright © 2005 ADTRAN 1041
certificate ca
Use the certificate ca command to restore a CA certificate. Use the no form of this command to remove a
specific certificate from the certificate chain for a CA.
Syntax Description
Specifies the certificate’s serial number (up to 51 characters). This value can be
found for existing certificates by using the show run command.
Default Values
No defaults necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 5.1 Command was introduced.
Functional Notes
The user typically does not enter this command. It is primarily used to restore certificates from the startup
configuration when the product is powered up.
Usage Examples
The following example removes the CA certificate with the serial number 0712:
(config)#crypto ca certificate chain MyProfile
(config-cert-chain)#no certificate ca 0712