ADTRAN 5000 Series - Manual (Page 1086)

Command Reference Guide AS Path List Command Set
61200990L1-35E Copyright © 2005 ADTRAN 1086
AS P ATH L IST C OMMAND S ET
To activate the Autonomous System (AS) Path List Configuration mode, enter the ip as-path-list
command at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#ip as-class-list listname
(config-as-path-list)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#>
on page 28
do on page 32
All other commands for this command set are described in this section in alphabetical order.
deny on page 1087
permit on page 1088