ADTRAN 5000 Series - Manual (Page 873)

Command Reference Guide Loopback Interface Configuration Command Set
61200990L1-35E Copyright © 2005 ADTRAN 873
ip pim-sparse propagation-delay
Use the ip pim-sparse propagation-delay command to specify protocol-independent multicast (PIM)
sparse join/prune propagation delay. This is the expected propagation delay in milliseconds over the local
link. Use the no form of this command to return to the default value.
Syntax Description
Specifies the expected propagation delay in milliseconds. Valid range is 0 to
32,767 milliseconds.
Default Values
By default, the propagation-delay is set to 500 milliseconds.
Applicable Platforms
This command applies to the NetVanta 2000 and 5000 and Total Access 900 Series units.
Command History
Release 11.1 Command was introduced.
Usage Examples
The following example sets the propagation-delay to 1000 milliseconds:
(config)#interface loopback 1
(config-loop 1)#ip pim-sparse propagation-delay 1000