ADTRAN 5000 Series - Manual (Page 1134)

Command Reference Guide Router (RIP) Configuration Command Set
61200990L1-35E Copyright © 2005 ADTRAN 1134
R OUTER (RIP) C ONFIGURATION C OMMAND S ET
To activate the Router (RIP) Configuration mode, enter the router rip command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#router rip
(config-rip)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#>
on page 28
do on page 32
end on page 33
exit on page 34
All other commands for this command set are described in this section in alphabetical order.
auto-summary on page 1135
timeout-timer on page 1142
network on page 1137
passive-interface on page 1138
redistribute connected [metric ] on page 1139
redistribute ospf [metric ] on page 1140
redistribute static [metric ] on page 1141
timeout-timer on page 1142
update-timer on page 1143
version [1 | 2] on page 1144