ADTRAN 5000 Series - Manual (Page 442)

Command Reference Guide Global Configuration Mode Command Set
61200990L1-35E Copyright © 2005 ADTRAN 442
router pim-sparse
Use the router pim-sparse command to globally enable protocol-independent multicast (PIM) on the unit
and to enter the PIM Sparse Configuration mode. Refer to the section Router (PIM Sparse) Configuration
Command Set
on page 834 for more information on the subcommands for PIM Sparse Configuration
mode.
Syntax Description
No subcommands.
Default Values
No default values necessary for this command.
Applicable Platforms
This command applies to the NetVanta 2000 and 5000 and Total Access 900 Series units.
Functional Notes
Additional commands for PIM are found in the related interface configuration modes. See the
ip pim-sparse commands in sections such as
Ethernet Interface Configuration Command Set on page
527 , Frame Relay Sub-Interface Config Command Set on page 714 , HDLC Command Set on page 782 ,
Loopback Interface Configuration Command Set on page 846 , PPP Interface Configuration Command Set
on page 883 , Tunnel Configuration Command Set on page 967 , and VLAN Interface Config Command Set
on page 668 for more information.
Command History
Release 11.1 Command was introduced.
Usage Examples
The following example uses the router pim-sparse command to enter the PIM Sparse Configuration
mode:
(config)#router pim-sparse
(config-pim-sparse)#