ADTRAN 5000 Series - Manual (Page 228)

Command Reference Guide Enable Mode Command Set
61200990L1-35E Copyright © 2005 ADTRAN 228
show ip route [connected | ospf | rip | static | table | bgp | summary |
summary realtime | ]
Use the show ip route command to display the contents of the IP route table.
Syntax Description
connected Optional. Displays only the IP routes for directly connected networks.
ospf Optional. Displays only the IP routes associated with OSPF.
rip Optional. Displays only the IP routes that were dynamically learned through RIP.
static Optional. Displays only the IP routes that were statically entered.
table Optional. Displays a condensed version of the IP route table.
bgp Displays only the IP routes associated with BGP.
summary Optional. Displays a summary of all IP route information.
summary realtime Optional. Displays full-screen output in realtime. See the Functional Notes below
for more information.
Displays only the IP routes to destinations within the given address and subnet.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 1.1 Command was introduced.
Release 10.1 The real time display option was introduced.
Functional Notes
Use the realtime argument for this command to display full-screen output in real time. Information is
continuously updated on the console until you either freeze the data (by pressing the F key) or exit
realtime mode (by pressing Ctrl-C). If there is not enough room on the screen for all available data, the
information will truncate at the bottom of the screen. In order to maximize the amount of data displayed,
increase the terminal length (using the terminal length command; refer to
terminal length on page
276 ).