Show lldp interface
Page 233

Command Reference Guide

Enable Mode Command Set

61200990L1-35E

233

show lldp interface

Use the show lldp interface command to display local loop demarkation point (LLDP) configuration and
statistics for interfaces on this device.

Syntax Description

Displays the information for the specified interface. Type show lldp interface ?
for a complete list of applicable interfaces.

Default Values

No default values are necessary for this command.

Applicable Platforms

This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.

Command History

Release 8.1

Command was introduced.

Usage Examples

The following example shows LLDP configuration and statistics for the Ethernet 0/1 interface:

>enable

#show lldp interface ethernet 0/1

eth 0/1 (TX/RX)

0 packets input

0 input errors

0 TLV errors, 0 TLVs Discarded

0 packets discarded

8799 packets output

0 neighbor ageouts

Page 233