Area stub [no-summary – ADTRAN 5000 Series User Manual
Page 1117
Command Reference Guide
Router (OSPF) Configuration Command Set
61200990L1-35E
Copyright © 2005 ADTRAN
1117
area stub [no-summary]
Use the area stub command to configure an area as a stub area. Use the no form of this command to
disable stub-designation for areas defined as stubs using this command.
Syntax Description
Specifies an identifier for this stub area. Specifies as an integer (range: 0 to
4,294,967,295) or an IP address
no-summary
Optional. Designates the area as a total stub area. No summary link advertisements
will be sent by the ABR into the stub area.
Default Values
By default, OSPF is not enabled.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 3.1
Command was introduced.
Technology Review
It is important to coordinate configuration of all routers and access servers in the stub area. The area stub
command must be configured for each of those pieces of equipment. Use the area router configuration
command with the area default-cost command to specify the cost of a default internal router sent into a
stub area by an ABR. Refer to
for related information.
Usage Examples
The following example configures area 2 as a stub area:
(config)#router ospf
(config-ospf)#area 2 stub