Bandwidth Page 534
Page 534
Command Reference Guide
Ethernet Interface Configuration Command Set
61200990L1-35E
Copyright © 2005 ADTRAN
534
bandwidth
Use the bandwidth command to provide the bandwidth value of an interface to the higher-level protocols.
This value is used in cost calculations. Use the no form of this command to restore the default values.
Syntax Description
Specifies bandwidth in kbps.
Default Values
To view default values, use the show interfaces command.
Applicable Platforms
This command applies to the NetVanta 300, 2000, 3000, 4000, and 5000 and Total Access 900 Series
units.
Command History
Release 3.1
Command was introduced.
Release 5.1
Command was expanded to include Ethernet sub-interfaces.
Functional Notes
The bandwidth command is an informational value that is communicated to the higher-level protocols to
be used in cost calculations. This is a routing parameter only and does not affect the physical interface.
Usage Examples
The following example sets bandwidth of the Ethernet 0/1 interface to 10 Mbps:
(config)#interface eth 0/1
(config-eth 0/1)#bandwidth 10000