ADTRAN 5000 Series - Manual (Page 1115)

Command Reference Guide Router (OSPF) Configuration Command Set
61200990L1-35E Copyright © 2005 ADTRAN 1115
area default-cost
Use the area default-cost command to assign a cost of the default summary route sent into a stub area or
not-so-stubby-area (NSSA). Use the no form of this command to delete the assigned cost.
Syntax Description
Specifies the identifier for this area. Specifies as an integer (range: 0 to
4,294,967,295) or an IP address .
Specifies the default summary route cost. Range: 0 to 166,777,214.
Default Values
By default the summary route cost is set to 0. There is no default for the area ID.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 3.1 Command was introduced.
Usage Examples
The following example defines a default cost of 85 to a specific area:
(config)#router ospf
(config-ospf)#area 192.22.72.0 default-cost 85