ADTRAN 5000 Series - Manual (Page 316)

Command Reference Guide Global Configuration Mode Command Set
61200990L1-35E Copyright © 2005 ADTRAN 316
crypto ca enroll
Use the crypto ca enroll command to begin CA enrollment procedures.
Syntax Description
Specifies a CA profile using an alphanumeric string (up to 32 characters).
Default Values
No defaults necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 5.1 Command was introduced.
Functional Notes
The type of enrollment procedure is based on the enrollment command and its settings. Refer to
enrollment terminal on page 1032 and enrollment url on page 1033 for more information. This
command initiates a dialog that is used to fill in the parameters that make up an enrollment request to be
forwarded to a certificate authority. Note that some of the parameters (such as IP address) may be filled in
using the values supplied in the crypto ca profile (in which case, the enrollment dialog will not prompt for
those parameters). Once all required parameters are defined using the dialog, this command assembles
them into an enrollment request to be sent to a certificate authority (including the generation of public and
private keys). Refer to
crypto ca profile on page 321 for more information.
If enrollment is set to terminal, you may view the request on the terminal screen.
If enrollment is set to url, the request is sent automatically to the certificate authority using the URL
specified by the enrollment url command.