Set transform-set Page 1051
Page 1051
Command Reference Guide
Crypto Map IKE Command Set
61200990L1-35E
Copyright © 2005 ADTRAN
1051
set transform-set
Use the set transform-set command to assign up to six transform sets to a crypto map. Refer to crypto
ipsec transform-set
for information on defining transform sets.
Syntax Description
Assign up to six transform sets to this crypto map by listing the set names,
separated by a space.
Default Values
By default, there is no transform set assigned to the crypto map.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 4.1
Command was introduced.
Functional Notes
Crypto map entries do not directly contain the transform configuration for securing data. Instead, the crypto
map is associated with transform sets which contain specific security algorithms (see
).
If no transform set is configured for a crypto map, then the entry is incomplete and will have no effect on
the system.
Usage Examples
The following example first creates a transform set (Set1) consisting of two security algorithms (up to three
may be defined), and then assigns the transform set to a crypto map (Map1):
(config)#crypto ipsec transform-set Set1 esp-3des esp-sha-hmac
(cfg-crypto-trans)#exit
(config)#crypto map Map1 1 ipsec-ike
(config-crypto-map)#set transform-set Set1