ADTRAN 5000 Series - Manual (Page 872)

Command Reference Guide Loopback Interface Configuration Command Set
61200990L1-35E Copyright © 2005 ADTRAN 872
ip pim-sparse override-interval
Use the ip pim-sparse override-interval command to specify the protocol-independent multicast (PIM)
sparse join/prune override interval. This delay interval is the period after a join/prune that another router on
the LAN may override a join/prune. Use the no form of this command to return to the default value.
Syntax Description
Specifies the delay time in milliseconds. Valid range is 0 to 65,535 milliseconds.
Default Values
By default, the override-interval is set to 2500 milliseconds.
Applicable Platforms
This command applies to the NetVanta 2000 and 5000 and Total Access 900 Series units.
Command History
Release 11.1 Command was introduced.
Usage Examples
The following example sets the override-interval to 3000 milliseconds:
(config)#interface loopback 1
(config-loop 1)#ip pim-sparse override-interval 3000